Emergency Solder Fittings for Plumbers

When attending a plumbing emergency, don’t always rely on push fit and compression fittings and make sure you have a decent stock of emergency solder fittings. most emergency plumbers when attending a plumbing emergency like to do an easy job, specially if the emergency is at 9pm at night and all you want to do is get home. It is always good to be prepared for the worse. If you have a leak to fix under the floor board for example, it is always good to carry emergency solder fittings to make the repair as compression fittings if out of site have a tendency to leak. Just below we have include a list of plumbing emergency materials.

• 8ml End feed copper couplings x2.
• 8ml End feed copper bends x2.
• 8ml End feed copper tees x2.
• 8ml End feed copper blanks x1.
• 10ml End feed copper couplings x2.
• 10ml End feed copper bends x2.
• 10ml End feed copper tees x2.
• 10ml End feed copper reducer x1.
• 15ml End feed copper couplings x4.
• 15ml End feed copper bends x4.
• 15ml End feed copper tees x2.
• 15ml End feed copper reducer to 10ml x1.
• 15ml End feed copper tap connector x2.
• 22ml End feed copper couplings x4.
• 22ml End feed copper bends x2.
• 22ml End feed copper tees x2.
• 22ml End feed copper reducer to 10ml x1.
• 22ml End feed copper tap connector x2.
• 22ml End feed copper to old 3/4 x2.
• 28ml End feed copper couplings x2.
• 28ml End feed copper bends x1.
• 10ml Copper pipe pipe x2 meters.
• 15ml Copper pipe pipe x6 meters.
• 22ml Copper pipe pipe x4 meters.
• 28ml Copper pipe pipe x1 meter.

Once you have you stock it is alway a good idea to keep a note pad in the from of your van to note down when the materials have been used. As an experience emergency plumber Martin Smith when attending a plumbing emergency find that in most cases the emergency solder fittings are not used very often.

What is the best type of solder fittings

The best type of solder fitting if you are a bigger are the Yorkshire fitting however if you are a fully qualified plumber with experience then it is better to use End Feed. If your a Gas Safe Registered engineer then it is a must that end feed fitting will be used all the time, not because of the quality but for the type of solder used in the fittings. If you are a customer reading this and require an emergency plumber anywhere in the UK. Please feel free to call and we will recommend a plumber. If your a plumber reading this then please feel free to register with us.